free plans for 10 x 12 skladovacie haly | Voľný Storage Shed Plans

Free 10 x 12 skladovacie haly plány

A 10 x 12 bouda plány is the ideal size for a backyard shed to store all your lawn equipment or outdoor toys. To small enough to be built with the help of a few people. Although the basic construction of the warehouse wouldn’t change, you can select the type of roof you feel and if you want to be put aside. It ‘best to use weather treated wood for this project, because it is the life of your building and prevent water damage to extend.

Budete potrebovať:

Measuring tape Post hole digger Four 4×4 posts 2×4 boards Plywood Nails Nail gun Roof trusses Felt paper Shingles Tyvek Siding Staple Gun Jigsaw Door Hinges Drill

1. Measure the percentage discount off the ground. In all corners of the room, you dig a hole with a 36-inch augers.

2. Place in 9 – 4×4 feet high in every hole and fill the hole with cement floor.

3. Starting from the bottom, nail 2×4 sheets for corner posts, each 16 centimeters to increase the pole up.

4. Nail the plywood sides of the shed. Of the 12 fields the hangar, you’ll need three plywood panels per page. In nails, tak, aby 4 set foot on land. The 10-foot Sides of the shed, you’ll have two plywood boards and a section of 2 feet of a third piece of plywood. Nail the plywood on each 2×4.

5. The walls on the upper level with 2×4 tables as an attachment to the corner seat.

6. Buy pre-fabricated, and adds them to the 2×4 at the top of the walls of the hangar.

7. To create nail plywood to the top of the roof of the cabin. The amount of plywood, you’ll have to buy the block size of the carrier.

8. Cover the plywood with felt paper and shingle on the paper felt.

9. Staple Tyvek on the exterior walls of the room.

10. Choose the type of door you need a shed. Depending on the size of the door or doors, which cut you choose, a hole in the front of the hangar large enough to accommodate the door. Be sure to measure twice and verify measurements before sawing the wood, it is important that the lines are straight. Nail 2×4 plates around the edge of the hole you cut for the doors to create a frame. Ensure the locked door to the frame, hinges 2×4. You’ll someone to help keep the doors, while the screws in the hinges need.

11. From wall siding hung in the hall, which is likely to match your home.